- Sanity check: make sure all cables are plugged into the right ports and the TV is set to the right setting. Still not working.
- Sanity check: turn off and on DVR and TV. Still not working.
- Move HDMI cable from port 1 to port 2 on TV, then port 3. Still not working.
- Get new HDMI cable from basement and test DVR and TV. Still not working.
- Test laptop HDMI into ports 1, 2, and 3 on TV. Laptop output to TV not working.
- Unplug power from TV, wait 10 seconds, plug back in. Eureka! It's working!
The trick is to continually isolate a single factor and remove that factor from consideration. If I had not tried the laptop, I doubt I ever would have figured out the problem. But I needed to test with an input other than the DVR to isolate the DVR and TV from each other to determine which was the problem. I'm just glad I was able to fix the TV so easily.
3 comments:
So wait...what was the problem? Why did rebooting the TV work?
your stack overflow profile kind of makes you look like you have T-Rex arms
Eric: My guess is that the HDMI decoder chip in the TV had some bad data somewhere, and by shutting off the power, the chip was able to reset itself and clear the bad data.
Adam: Yes, I do have T-Rex arms. The camera shows me as I really am.
Post a Comment